Is the below config a possible correct answer for Task 2.4?

 

!
mac access-list extended ROUTER
 permit host 0030.1369.87a0 any
!
vlan access-map STOP_ROUTER 10
 action drop
 match mac address ROUTER
!
vlan filter STOP_ROUTER vlan-list 17

Firstly, matching a MAC ACL will only match non-IP traffic (e.g. ARP, VTP, STP). In your case, the host will still be able to send IP packets e.g. by using static ARP entries. Secondly, you vlan filter misses another statement that permits all other traffic. In effect, it will filter ALL non-IP traffic on the  VLAN it maps onto.

Notice I was missing the second permit statement in my VLAN filter when I had EIGRP nei problems.

Thank you for your help.

I think there is a small violation, init config for SW1 have:

interface range Fa0/7 - 8
 switchport access vlan 17
 no shutdown

Task 2.1 requires us to:

Rack1SW1#show vlan brief | exclude (unsup|^1 |^ )
VLAN Name Status Ports
---- -------------------------------- --------- -------------------
3   VLAN0003       active Fa0/3
17 VLAN0017        active Fa0/1
22 VLAN0022        active
33 VLAN0033        active
38 VLAN0038        active
45 VLAN0045        active
46 VLAN0046        active
58 VLAN0058        active Fa0/5
Rack1SW1#

and SG for 2.4 uses vlan 17 for f0/7 and f0/8. While doing troubleshooting for task 1 I removed switchport access vlan 17 thinking that is a mistake since 2.1 do not show f0/7 & f0/8 as a vlan 17 member ports. As for solution: lab 11 have the same issue with mac ACLs which will not match IP traffic, but hands just configured mac ACL. Thanks IE for this nice coaching.

I do as well remove vlan 17 from 8 and 7 thiking it is a mistake , can you explain this  more ?