CCIE - Internetwork Expert's Online Community

I am new on the lab, and today is the first time i log into the lab. after getting used to the environment.....

i started sesion 1.1; First of all, i downloaded the "full layer 2" initial config to my config. One of the task is asking to assign VLAN to switch port, but I found

out on the config for this are already on the initial config., so do the vlans are also created. Then I try to ping the ip as mentioned on the labbook, but wasn't

successful.

Did i got the wrong initial script or i need to use some other initial config script to do the practice?

Or should i try to upload the indiviual session script (trunking, span-tree, etc)? 

have anyone try those before, and go through ok?

any suggestion is appreciated.

thanks! i will try this. My assumption will be by using the basic ip addressing initial configuration, i hope i can pretty much follows through the lab

from session 1.1 through the end of the workbook I; with some minor change on the way based on the question...I also saw there are some config

when i go to the lab (under the control panel??), you can pick each individual session, do someone try that before?

thanks.

I'm also new to this.  Please correct my understanding if I'm mistaken.

From "basic.ip.addressing" I should swap the initial configuratios of all devices (r1-r6, sw1-sw4) with the existing initial configs.  For example, open "ie.routing.and.switching.topology.4.10.net" and redirect:

cnfg = C:\Program Files\Dynamips\sample_labs\internetworkexpert\initial.configs\R1.initial.config.txt

to the configurcation r1.txt" of "basic.ip.addressing"

Is this correct?